SRC300 Remote

Click on your Remote for Programming Instructions

STEP 1 - Finding the Gateway ID
Start here if you are programming a new remote. This step has to be performed at the RG. If the TV is not located with the RG, you may need another person. The following information appears on channel 3 or 4, stream 1 on your TV screen:

  1. On the RG - Press the Menu or the Wrench button 1 time
  2. On the RG - Press the Channel Down button or the Arrow Down button 1 time to “Remote Control Setup”
  3. On the RG - Press the Select or the Check Mark button 1 time
  4. On the Remote Control - Press the PPV button
  5. Find the line that reads: “The Gateway ID is set to:” (3 digit code) or “This Gateway requires a Gateway ID of:” (3 digit code - ranges from 004-255)

(If nothing appears on the TV screen when you Press the PPV button, please call our Repair Department at 611 or 772-8611.)

STEP 2 - Programming the Gateway ID

  1. On the Remote Control – Press the LED button and hold it down until the LED button starts flashing.
  2. On the Remote Control – Press the REC button (blue button with red dot). The LED button stops flashing and stays on solid red.
  3. On the Remote Control – Press the B button. The Remote is now in programming mode.
  4. Now enter the Gateway ID from above.
  5. On the Remote Control the red LED red light goes off.

STEP 3 - Finding and Programming the Remote Control
   TV - 1 Stream 1  Can be channels 3, 4, 5 or 6 
   TV - 2 Stream 2  Can be channels 7, 8, 9 or 10

   TV - 3 Stream 3  Can be channels 11, 12 or 13

  1. On the Remote Control – Press the LED button and hold it down until the LED button flashes rapidly.
  2. On the Remote Control - Press the REC button (blue button with the red dot). The LED button stops flashing at this point and stays solid red.
  3. On the Remote Control – Press the A button . The remote is now in programming mode.
  4. Enter the single-digit Remote Control ID from the table above. (Example: A1)
  5. Your remote control should now be able to change channels, if not, start at Step 1 again.

(Note: HD TV’s must have the Remote Control ID of “A0”)
STEP 4 – Programming the TV Code using the Code Search Method (Controls Volume, Mute and Power)

  1. Turn your TV on.
  2. On the Remote Control – Press the LED button and hold it down until the LED button flashes rapidly.
  3. On the Remote Control – Press the REC button (blue button with red dot.) The LED button stops flashing at this point and stays solid red.
  4. On the Remote Control – Press the Power button (the large white button in the upper right hand corner). The remote is now in TV code scan programming mode.
  5. While pointing the remote at the TV, SLOWLY press and release the blue down arrow button to scan through all the TV codes; continue to press and release. When you reach the correct TV code, the TV will turn off.
  6. On the Remote Control – Press the Select button to lock in the TV Code. The LED light will flash and then will go off indicating the TV code has been stored.
  7. The volume , mute and power buttons should now work, if they do not, repeat Step 4.