STEP 1 - Finding the Gateway ID

Start here if you are programming a new remote. This step has to be performed at the RG. If the TV is not located with the RG, you may need another person. The following information appears on channel 3 or 4, stream 1 on your TV screen:

1. On the RG - Press the Menu or the Wrench button 1 time
2. On the RG - Press the Channel Down button or the Arrow Down button 1 time to “Remote Control Setup”
3. On the RG - Press the Select or the Check Mark button 1 time
4. On the Remote Control - Press the PPV button
5. Find the line that reads: “The Gateway ID is set to:” (3 digit code) or “This Gateway requires a Gateway ID of:” (3 digit code - ranges from 004-255)

(If nothing appears on the TV screen when you Press the PPV button, please call our Repair Department at 611 or 772-8611.)

STEP 2 - Programming the Gateway ID

1. On the Remote Control - Press and hold the B button until the red light on the remote control starts flashing.
2. On the Remote Control - enter 7-8-9. If you enter the valid 3-key sequence, the red light will remain on.
3. Now enter the Gateway ID code from above.
4. On the Remote Control - the light should go off.

1. On the Remote Control – Press the A button until the red light starts flashing rapidly.
2. On the Remote Control – enter 7-8-9 and the red light will stay on.
3. Enter the single-digit Remote Control ID from the table above. (Example: 789-1)
4. If you entered the single-digit code correctly, the red light flashes and then goes off.
5. Your remote control should now be able to change channels properly, if not, start at Step1 again.

(Note: HD TV’s must have the Remote Control ID of “A 789-0”)

STEP 4 – Programming the TV Code using the Code Search Method (Controls Volume, Mute and Power)

1. Turn your TV on.
2. Point the Remote Control at the TV. Press the Mute button and hold it down until the red light flashes rapidly.
3. On the Remote Control – Press the Green Power button. The red light will appear and stay on.
4. While pointing the remote at the TV, SLOWLY press and release the blue down arrow to scan through all TV codes; continue to press and release. When you reach the correct TV code, the TV will turn off.
5. On the Remote Control – Press the Select button to lock in the TV code. The red light will flash and then go out, indicating the TV code has been stored.
6. The volume, mute and power buttons should now work, if they do not, repeat Step 4.