Programming
Your Remote - SRC350
|
|
|
| |
STEP 1 - Finding the Gateway ID
Start
here if you are programming a new remote. This step has to be
performed at the RG. If
the
TV
is not
located
with
the RG, you
may need another person. The following information appears on
channel 3 or 4, stream 1 on your TV screen:
- On the
RG - Press the Menu or the Wrench button 1 time
- On the RG
- Press the Channel Down button or the Arrow Down button 1 time
to “Remote
Control Setup”
- On the RG
- Press the Select or the Check Mark button 1 time
- On the Remote
Control - Press the PPV button
- Find the
line that reads: “The
Gateway ID is set to:” (3
digit code) or “This Gateway requires a Gateway
ID of:” (3
digit code - ranges from 004-255)
(If nothing
appears on the TV screen when you Press the PPV button, please
call our
Repair Department at
611 or 772-8611.)
|
|
STEP
2 - Programming the Gateway ID
- On the Remote Control - Press and hold the Select and
Mute buttons down together until the LED button lights up and
stays on.
- On the
Remote Control - Press the B button. The remote is now in programming
mode. You can set the Gateway ID from
above.
- On the
Remote Control – If
you have entered the Gateway ID correctly,
the LED blinks 3 times and goes off.
|
|
| STEP
3 - Finding and Programming the Remote Control ID |
| |
Channel |
Remote
ID |
Stream |
Operates
TV |
Mode |
3,4 |
0 |
Stream 1 |
TV and RG must be positioned together |
Infrared |
3,4 |
1 |
Stream 1 |
TV and RG can be in a different room than
TV 1 |
|
7 |
2 |
Stream 2 |
TV and RG can be in a different room than
TV 2 |
|
13 |
3 |
Stream 3 |
TV and RG can be in a different room than
TV 3 |
|
|
TV
- 1 Stream 1 Can be channels 3, 4,
5 or 6
TV - 2 Stream 2 Can be channels 7, 8,
9 or 10
TV - 3 Stream 3 Can be channels 11,
12 or 13
|
| |
- On the Remote Control - Press and hold the Select and Mute
buttons down together until the LED button lights up and stays
on.
- On the Remote Control - Press the A button. The LED remains
on. The remote is now in programming mode.
- Now enter
the single-digit Remote Control ID from the table above. (Example – A1)
- Your remote should now be able to change channels, if not, start
at Step 1 again.
(Note: HD TV’s must have the Remote Control ID of “A0”)
|
|
STEP
4 – Programming
the TV Code using the Code Search Method (Controls Volume, Mute
and Power)
- Turn your TV on.
- On the Remote Control - Press and hold the
Select and Mute buttons down together until the LED button
lights up and stays
on.
- While pointing the Remote Control at the TV, SLOWLY
press and release the blue down arrow button until the TV turns
off.
(The
correct TV code makes the TV turn off.)
- Once the TV turns off,
on the Remote Control - Press the Select button to lock the
TV code.
- The volume, mute and power buttons should now work,
if they do not, repeat Step 4.
|
| |
|
| |
